19 lines
789 B
Markdown
19 lines
789 B
Markdown
# TODO
|
|
|
|
Notes for "next time".
|
|
|
|
## v2
|
|
|
|
* I need at least 5mm, maybe 10mm, more height, to fit some of my levers like the Nobi Bullet
|
|
* I couldn't even fit a JLF without the compensations in v1 on the bottom panel
|
|
* I had to bend the pins a bit on Crown SDB-202s, too
|
|
* The plates bow a bit on the top when pressure is applied, because there's no support from the frame up there ---
|
|
adding 5mm to the frame should leave a couple mm for support to get added back
|
|
* PCB mount on `top-panel-dir_arc-plus-w-30mm-plus-one-with-mount.scad` doesn't leave room for a USB cable on the right
|
|
hand side
|
|
|
|
## v3
|
|
|
|
* Check that the 24mm cutouts in the frame are good enough, somehow I didn't have them when I printed v2
|
|
* Engraving some cosmetic stuff? Or maybe a place to mount other plates?
|