this is just an aesthetic choice, but I think 2+ tone colorways will
look slightly nicer if the whole side panel color runs along the whole
side rather than stopping at the top/bottom "lip". the actual difference
is arbitrary but I'm going to toy with this for now as I suspect side
colors and panels will be more interesting than top/bottom ones
Signed-off-by: Brian S. Stephan <bss@incorporeal.org>
this provides a system for interlocking frame walls as separate pieces,
rather than a whole frame box as one piece. the primary motivation for
this was to improve print quality. these pieces can be printed flat side
down, meaning improvements due to:
1. printing the box required the long, thin bottom to be the side on the
print surface, which meant shrinkage force would curl the corners
with essentially no remedy outside of bed adhesive
2. printing the box bottom up created poor circles for the button holes,
sometimes bad enough to be a visible problem, as well as making small
flow glitches to stand out (especially on non-matte PLA)
3. printing the box also required supports when the frame bottom was
inset-style, leading to an annoying post-print step
4. the outward side is now what rests on the print surface, yielding a
nicer, more consistent surface
the box modules still exist in the event someone wants them, but I
personally will probably be focused on this method going forward. this
also opens up some exciting options regarding color mixing, different
side panel shapes, and the like, so I expect to see more of these even
if the boxes don't go away (especially since these new pieces are all
derived from the boxes anyway).
Signed-off-by: Brian S. Stephan <bss@incorporeal.org>
