Brian S. Stephan
bc68f8b0dc
vertical planes that make up the frame are either sides or front/back Signed-off-by: Brian S. Stephan <bss@incorporeal.org>
38 lines
1.4 KiB
OpenSCAD
38 lines
1.4 KiB
OpenSCAD
/*
|
|
* SPDX-FileCopyrightText: © 2024 Brian S. Stephan <bss@incorporeal.org>
|
|
* SPDX-License-Identifier: GPL-3.0-or-later
|
|
*/
|
|
|
|
include <parameters.scad>
|
|
include <components.scad>
|
|
use <frames/complete/left-frame.scad>
|
|
use <frames/pieces/box/side.scad>
|
|
use <front-or-back-clean-for-extended-side.scad>
|
|
|
|
module side_frame_piece_wall() {
|
|
// get a slice of the piece, to use it in extruding
|
|
// this doesn't use the side_frame_piece because of the 45 degree angle geometry
|
|
// not creating a clean thing to cut, so we just take the whole wall and use that
|
|
projection(cut=true) rotate([0, 90, 0]) translate([frame_x/2-frame_wall-(frame_bevel_height/2), 0, 0])
|
|
left_frame();
|
|
}
|
|
|
|
module side_frame_piece_extension() {
|
|
// combine the original with a shrunken piece to "pull" the wall out
|
|
hull() {
|
|
linear_extrude(height=frame_extension_y) scale([0.5, 0.85, 1]) side_frame_piece_wall();
|
|
linear_extrude(height=frame_bevel_height) side_frame_piece_wall();
|
|
}
|
|
}
|
|
|
|
module extended_bottom_left_or_right_frame_piece() {
|
|
difference() {
|
|
side_box_frame_piece();
|
|
// chop off the old edge which is getting replaced with the extension
|
|
translate([-frame_x/2+frame_bevel_height/2, 0, 0]) cube([frame_bevel_height, frame_y, frame_z], center=true);
|
|
}
|
|
translate([-frame_x/2+frame_bevel_height*2, 0, 0]) rotate([0, -90, 0]) side_frame_piece_extension();
|
|
}
|
|
|
|
extended_bottom_left_or_right_frame_piece();
|