Brian S. Stephan
29fb93ee51
it just stands out a bit too much at the default, IMO, considering the button is standalone and not part of a 24mm layout where the default is nicer Signed-off-by: Brian S. Stephan <bss@incorporeal.org>
36 lines
1.5 KiB
OpenSCAD
36 lines
1.5 KiB
OpenSCAD
/*
|
|
* SPDX-FileCopyrightText: © 2024 Brian S. Stephan <bss@incorporeal.org>
|
|
* SPDX-License-Identifier: GPL-3.0-or-later
|
|
*/
|
|
|
|
include <parameters.scad>
|
|
decorative_radius_scale = 1.5;
|
|
include <components.scad>
|
|
|
|
module dir_arc_plus_w_30mm_and_sega_2p_nine_decorative_plate_of_plates() {
|
|
difference() {
|
|
// layout offset + 30 = width for layout plus button width + 19+3 = space around button
|
|
left_plate_x = dir_arc_30mm_column_3_offset + 30 + 19;
|
|
// layout offset + 30 = width for layout plus button width + 19+3 = space around button
|
|
left_plate_y = dir_arc_w_30mm_row_4_offset + 30 + 19;
|
|
left_plate_center_x = (left_plate_x + sega_2p_column_1_left_panel_edge_offset - 22)/2;
|
|
// layout offset + 30 = width for layout plus button width + 19+3 = space around button
|
|
right_plate_x = sega_2p_column_4_offset + 30 + 19;
|
|
right_plate_center_x = (right_plate_x + sega_2p_column_1_left_panel_edge_offset - 22)/2;
|
|
|
|
union() {
|
|
// y values are based on the other half below
|
|
translate([right_plate_center_x, 15, 0]) linear_extrude(2) offset(r=3, $fn=100)
|
|
square([right_plate_x, left_plate_y], center=true);
|
|
translate([-left_plate_center_x, 15, 0]) linear_extrude(2) offset(r=3, $fn=100)
|
|
square([left_plate_x, left_plate_y], center=true);
|
|
/* translate([-50, 0, 0]) cube([200, 200, 2], center=true); */
|
|
}
|
|
// cut out the normal holes
|
|
translate([-panel_x/2, 0, -1]) dir_arc_w_30mm();
|
|
translate([panel_x/2, 0, -1]) sega_2p_nine();
|
|
}
|
|
}
|
|
|
|
dir_arc_plus_w_30mm_and_sega_2p_nine_decorative_plate_of_plates();
|